3724 posts · Joined 2008. #2 · Sep 13, 2009. To enter the instrument cluster Self-Diagnostic Mode simultaneously press and hold the tripmeter reset button and turn the ignition switch to position II. When tESt is displayed in the LCD release the button. The instrument cluster will enter the gauge sweep test.
The frontal barrier test simulates a head-on collision between two similar vehicles, each moving at 35 mph. Combines Side Barrier and Side Pole Star Ratings into a single side rating. Combines the Side Barrier Driver and the Side Pole Star Ratings into a Front Seat rating.

Checked my temps yesterday using TEST Mode. Ambient temp was 96*F - 98* F or around 36*C. Idling in Park with AC ON gave me 103*C, Idling in Drive with AC ON gave me 113*C to 115*C (235.4*F to 239*F). While driving, temps were around 109*C (228.2* F). Temp neveer went into the red, but sure scared me.

I have just done the diagnostics check through the dashboard on my focus mk3 and the car has thrown up 6 fault codes. I need urgent help to understand what the codes are and what they mean. c140_00 - 1st dtc. c121_00 - 2nd dtc. 1607_82 - 3rd dtc (there was no letter on the dash) c151_00 - 4th dtc. c214_00 - 5th dtc. My Focus 2002 battery light had been coming on randomly over the last few weeks. Today it stayed on. I ran the odo test mode (with dtc: none), but I am unsure how to determine from this information what my issue might be. I looked at a list of odo test sequences. New battery, solid terminal connections. I would like to avoid taking it to the shop.
Within 10 seconds, the display should change to "test" in LCD font and the needles will do a full sweeping. Release the Button Pressing the button will now cycle through some 17 different modes 1.Shows a Gauge Sweep 2. Shows all 8's on the LCD (LCD TEST) 3. Illuminates all the bulbs on the dash 4. Displays hexadecimal value for ROM level 5.
On 3/9/2017 at 3:45 AM, dancki. - dtc f00616. - dtc c41568. - dtc c41668. Those codes decode to: U3006-16: Battery voltage (Low or high) U0415-68: . U0416-68: Invalid Data Received From Vehicle Dynamics Control Module. Like Clive says, these codes can be caused by some little glitch, and may not mean anything.
Clear all faults and clear the PCM adaptive memory (PCM Reset). Set the ignition switch to the run position and wait until all the instrument warning lamps are of. Repair any unwanted warning lamps before proceeding. The PCM will sweep the throttle body blade to learn the new positions.

Estate 1.5L Ford EcoBlue 120PS Diesel 8 Speed Automatic FWD G 127 No 20,895.83 25,075.00 25,370.00 133.87 267.73. Ø The CO. 2. emissions test figures shown in the table are derived from the Worldwide Harmonised Light Vehicle Test Procedure (WLTP) .

Rpjk.
  • 8dnuh51qcl.pages.dev/468
  • 8dnuh51qcl.pages.dev/444
  • 8dnuh51qcl.pages.dev/349
  • 8dnuh51qcl.pages.dev/27
  • 8dnuh51qcl.pages.dev/279
  • 8dnuh51qcl.pages.dev/78
  • 8dnuh51qcl.pages.dev/483
  • 8dnuh51qcl.pages.dev/140

    • ford focus test mode list